Cisco DWDM-SFP10g Compatible 10g DWDM SFP+ 40km Eml50GHz/100GHz Pin Duplex LC SMF Transceiver for Transmission, #A0042

• Wiring Devices: Fiber Optic Cabling
• Certification: RoHS
• Data Rate: up to 11.3gbps
• Power Dissipation: < 1.0W
• Part Number: Tssls-Dxxch4c
• Tx/Rx: Eml/Pin
• Model NO.: TSSLS-DXXCH4C
• Reach: 40km
• Transport Package: Nautral or Customized
• Specification: 10G SFP+ DWDM 40KM
• HS Code: 8517795000

Product Description

 

Product Description

Features
Compliant with SFF-8431 MSA
Compliant with SFF-8432 MSA
Hot-Pluggable SFP+ Footprint
Data rate up to 11.3Gbps
Available in all C-Band Wavelengths on the 100GHz DWDM ITU Grid
Temperature-Stabilized DWDM EML Transmitter
Power Dissipation < 1.5W
Duplex LC Connector
Distance up to 40km
Specifications compliant with SFF 8472
2-wire interface with integrated Digital Diagnostic monitoring
Dispersion tolerance from -300ps/nm to 800ps/nm
Case operation temperature range :
Standard: temperature 0°C to 70°C
Industrial temperature: -40°C to 85°C
RoHS6 compliant (lead free)


Applications
10GBASE-ER/EW
10G FC


Product Description
The TSSLS-DXXCH4 series single mode transceiver is small form factor pluggable module for duplex optical data communications. This module is designed for single mode fiber and operates at a nominal DWDM wavelength from 1528nm to 1566nm as specified by the ITU-T.
It is designed to deploy in the DWDM networking equipment in metropolitan access and core networks. It is with the SFP+ 20-pin connector to allow hot plug capability. The transmitter section uses a DWDM EML laser and is a class 1 laser compliant according to International Safety Standard IEC-60825.
The receiver section uses a PIN detector and a limiting post-amplifier IC. The TSDP-XX192L-L4 series are designed to be compliant with SFP+ Multi-Source Agreement (MSA) Specification SFF-8431.


Absolute maximum rating
These values represent the damage threshold of the module.  Stress in excess of any of the individual Absolute Maximum Ratings can cause immediate catastrophic damage to the module even if all other parameters are within Recommended Operating Conditions.

Parameters	Symbol	Min.	Max.	Unit
Power Supply Voltage	VCC	-0.5	+3.6	V
Storage Temperature	Tc	-40	+85	°C
Relative Humidity	RH	0	85	%

Recommended Operating Conditions

Parameter	Symbol	Min	Typical	Max	Unit
Supply Voltage	VCC	3.15	3.3	3.45	V
Supply current	Icc	-	-	435	mA
Operating Case Temperature (Standard)	Tca	0	-	70	ºC
Operating Case Temperature (Industrial)	Tca	-40	-	85	ºC

Notes:
1. Supply current is shared between VCCTX and VCCRX.
2. In-rush is defined as current level above steady state current requirements.


Electrical characteristics

Parameter	Symbol	Min.	Typical	Max	Unit	Ref.
Transmitter
Data Rate	Mra	1.0	10.3	11.3	Gbps	-
Input differential impedance	Rin	-	100	-	Ω	1
Differential Input Voltage swing	Vin	150	-	1200	mV	-
Transmit Disable Voltage	VD	2.0	-	VCC+0.3	V	-
Transmit Enable Voltage	Ven	Vee	-	Vee+0.8	V	2
Transmit Disable Assert Time	Vn	-	-	100	us	-
Receiver
Data Rate	Mra	-	10.3	11.3	Gbps	-
Output differential impedance	Rout	-	100	-	Ω	1
Differential Output Swing	Vout	300	-	700	mV	3
Loss of Signal -Asserted	-	2.0	-	VCC+0.3	V	4
Loss of Signal -Negated	-	Vee	-	Vee+0.8	V	4

Notes:
AC coupled.
Or open circuit.
Into 100 ohm differential termination.
LOS is LVTTL. Logic 0 indicates normal operation; logic 1 indicates no signal detected.


Transmitter Specifications - Optical

Parameter	Symbol	Min	Typical	Max	Unit
Average Optical Power[1]	Po	-1	-	+4	dBm
Side Mode Suppression Ratio	SMSR	30	-	-	dB
Center Wavelength Spacing			0.8		nm
Extinction Ratio	ER	3.0	-	-	dB
Transmitter and Dispersion Penalty @800ps/nm	TDP	-	-	3.0	dB
Average Launch Power of OFF Transmitter	Poff	-	-	-30	dBm

Receiver Specifications - Optical

Parameter	Symbol	Min	Typical	Max	Unit
Receiver sensitivity in 10.5Gbps(OMA)[2]	Rsen	-	-	-14.1	dBm
Receiver Overload	Pmax	-1	-	-	dBm
LOS Asserted	Lsa	-28	-	-	dBm
LOS De-Asserted	Lda	-	-	-16	dBm
LOS Hysteresis	Lh	0.5	-	-	dB

Notes:
Output is coupled into a 9/125μm single-mode fiber.
BER less than 1E-12. The measure pattern is PRBS 231-1.


Low Speed Characteristics

Parameter	Symbol	Min	Typical	Max	Unit
TX_Fault,RX_LOS	VOL	0	-	0.4	V
	VOH	Host_VCC-0.5	-	Host_VCC+0.3	V
TX_DIS	VIL	-0.3	-	0.8	V
	VIH	2.0	-	VCCT+0.3	V
RS0,RS1	VIL	-0.3	-	0.8	V
	VIH	2.0	-	VCCT+0.3	V

Please visit T&S Communications Co., Ltd. website for complete information.